SlickMod - Premium Auto Films

Frequently Asked Questions

 

  • 1. How long will it take to ship my order?

    Every precut order is custom manufactured after you place your order. Most orders will ship within 1-2 business days.
    Please allow at least 2-3 business days for international orders.

  • 2. How long will it take to get my order?

    Once the item is shipped out, a tracking # will be provided. It usually takes about 2-6 business days after the item is shipped out.
    International orders will take about 14-21 business days.

  • 3. Can I install SlickMod products by myself?

    Yes! Install guide is provided. We only ask that once you do the installation, please allow between 1-3 hours for a good install.
    Have alot of patience and follow instructions closely. Do not hesitate if you get a wrinkle in the film.
    Please refer to installation guide on our website on how to get it on smoothly.
    SlickMod makes every effort to ensure that all of our pre-cut kits are made for fitment on each specific make and model as
    advertised.
    However, a "professional quality" installation does require some acquired knowledge and mechanical ability, for which Slickmod
    cannot be held responsible for any failed installs. We will provide instructions with your order and can provide assistance if needed.

  • 4. How thick is the film?

    3 mil thick

  • 5. What do I do if I have water bubbles after the install?

    Please leave the vehicle outside in the sun so it can cure. The bubbles should disappear in a few days.

  • 6. How do I remove the film from lights?

    Upon initial application, the film can be pulled up and reapplied numerous times until you are pleased with the results.
    However, after the film has settled (approximately 24-48 hours), the product is not considered reusable.
    To permanently remove the film, we recommend warming it with a heat gun, hair dryer, or simply park the vehicle in the sunlight
    on a warm day. With the film warm, slowly peel the film from the lens surface. Any adhesive that may be left on the lens can be
    removed with a cleaner that is safe for use on an autos exterior. We recommend bug and tar remover or goo gone.

  • 7. Are colored films legal for street use?

    Installing vinyl overlay on vehicles primary lighting may not be legal for street use.
    Installation of colored films is meant for off road use purposes only.
    Using colored films on your primary lights is done so at your own risk. Please consult all state laws before applying to any lens.

  • 8. How much light will be able to shine thru with 20% dark smoke? 35% light smoke?

    20% Smoke (Dark): Allows 67% Light Transmission
    35% Smoke (Light): Allows 87% Light Transmission

  • 9. Do you have warranty?

    We offer 7-Year Guarantee from the date of purchase. The products are guaranteed against defective materials and workmanship;
    however, the guarantee is null and void if the products have been improperly handled or applied. Neither the seller nor the
    manufacturer shall be liable for any injury, loss, or damage, direct or consequential, arising out of the use or inability to use the
    products.
    If the product is not proven to conform to specifications, the seller's obligations shall be to replace it at no cost to the purchaser.
    All expressed or implied rights, warranties, guarantees, or conditions, statutory or otherwise, are excluded.
    The foregoing may not be altered, except by agreement signed by the buyer and seller, and is void where prohibited by law.
    During the warranty period, your SlickMod product will be replaced free of charge, upon approval, when proof of purchase
    and the defective product is returned back to the seller or the manufacturer.